Ross Engineering Motorsport Developments

02/05/2023

Watch Judy Justice

07/07/2022

04/26/2022

Still the number one place for Consulting service Want to go fast do it right

04/20/2022

Another fine piece

08/11/2021

To be the best don't be like the rest

07/11/2020

Corrections to my previous post
How many times have you thought about building a new race car with ether a Pushrod or Pullrod front suspension or rear suspension with Bellcranks but didn’t because you are not sure how to calculate the Bellcrank ratio or the combined suspension ratio. Well we have a program that does it for you. Let’s say you want to try it on the rear of the car. Example Place a strait edge against the inside edge of one rear tire about3” up from the bottom then place another strait edge against the out side of the other rear tire that is your tread width. Then measure the space between the proposed Bellcrank locations. That’s the only measurements you need to make. The program figures out the rest for you. The front with ether Pushrod or Pullrod is just as easy just 3 measurements by you and the program figures out the rest.