Wildtech

Wildtech New and innovative technology aimed to maximize the experience and minimize the environmental footprint

One step closer.
02/05/2026

One step closer.


One step forward…It was impossible to find new hinges with the correct hole pattern. I ended up hard soldering brass to ...
18/04/2026

One step forward…

It was impossible to find new hinges with the correct hole pattern. I ended up hard soldering brass to the old hinge. This allowed me to move the holes for the screws to an area of the frame which has more material.


12/04/2026

Feeling fast today.

All systems are go!
11/04/2026

All systems are go!

First harvest of the year! (F)artichoke, ain’t no joke!
29/03/2026

First harvest of the year! (F)artichoke, ain’t no joke!

29/03/2026

🥔 prep!

3 out of 8 coats…cgpettersson
28/03/2026

3 out of 8 coats…

cgpettersson

After what feels like forever, first coat!
22/03/2026

After what feels like forever, first coat!


Back at it with the window frames. The old center frame was in bad shape and hade a interesting ”quick fix”. The two sm...
14/03/2026

Back at it with the window frames. The old center frame was in bad shape and hade a interesting ”quick fix”. The two smaller frames had part of the frame replaced due to cracks. There’s no stop on the hinge and very little material to fasten the hinges in. Hoping to find a better solution to this.

Home assistant update! I wanted a way to remotely monitor the battery status of boats and vehicles on the island. I use ...
24/02/2026

Home assistant update! I wanted a way to remotely monitor the battery status of boats and vehicles on the island.

I use products from Jkbms in Elektra, the ATV and the Volvo c202. Elektra and the ATV use the bms+balancer while the c202 uses three CAN-enabled balancer-only devices.

Common for all is the use of Bluetooth. The HA Rpi 5 is located in the house and the Bluetooth signal is not strong enough. I used esp32 devkits with external antenna to create a ble-to-WiFi bridge. One esp32 responsible for polling data from the c202 and the ATV. Another esp32 is used to monitor Elektra.

A “card” is created in HA for each battery pack. The ATV has a built in battery pack heater and with the use of a Shelly plug I’m able to control heating and charging remotely. The same will be implemented in the c202.

HA opens up a world of possibilities. For example, why not use the 20kWh in Electra as a “home battery”?

More to come!

Thinking about boating! it’s going to take a fair amount of energy to turn this mess into water again :)
07/02/2026

Thinking about boating! it’s going to take a fair amount of energy to turn this mess into water again :)

Adress

Stockholm

Webbplats

Aviseringar

Var den första att veta och låt oss skicka ett mail när Wildtech postar nyheter och kampanjer. Din e-postadress kommer inte att användas för något annat ändamål, och du kan när som helst avbryta prenumerationen.

Genvägar

Dela

Typ