Bike Fix PH

20/05/2023

Workshop randoms
Tis the season to fix some bikes
Learn to change gears so you don't wear out a single cog in your cassette...

02/04/2023

Uploading some photos of projects from before closing shop so I can clear my phone's memory. Cheers!

15/02/2023

Bikefixph is no longer in operation as of February 15, 2023.
Thank you to all our clients, those that took a chance and the ones that became regulars, for trusting us with your bikes. You gave us purpose and stability in a time where most businesses struggled to survive.
Thank you for your patience during times when we were overwhelmed with work and backlogs.
Thank you for partnering with us for your events, advocacies and races. These showed us that our work wasn't just about the bikes but about the communities that revolved around them.

I am forever grateful for the opportunities that have come and friendships formed from this small enterprise that was started as a means to survive when I lost my job in the pandemic.

Onwards and upwards 🙌

*following posts will be work done from Oct 2022 to Jan 2023*

14/02/2023

Advisory
This vehicle,
Isuzu Fuego Pickup 1998
Emerald Green
WDH 192
Is no longer associated or in use by BikeFixPh or its owners.

Thank you

16/12/2022

Finding a leak!
Fluid flush
Observe
Full brake disassembly
Inspection
Pressure testing
Rebuild
Bleed again
Observe some more...

09/12/2022

What a great weekend supporting the .official mtb team during the Tarlac Enduro Attack 2 day enduro race.

Thank you Fly Racing and for trusting BikeFixPh!

28/11/2022

No chain guide or tensioner
No problem!
Mountain dew saves the race day for and his DH bike

28/11/2022

Quick way to check your tubeless tire sealant level and condition.
Get yourself a small cable tie and cut off the pointy end.
Remove your valve cores.
Stick the cable tie all the way inside the valve stem with the valve at the 6 o'clock position.
Pull out the cable tie and some sealant should be on the end of it. You can estimate how much sealant is inside your tires by how much of the cable tie is covered. You can also tell a bit about the sealant condition, if it's too clear and watery or if it still looks fresh.
This is also a good time to clean out the valve stems and replace cores if you've noticed it's difficult to inflate your tires.

22/11/2022

Was a great Sunday supporting the .official mtb team at the Bentebentedos downhill race in the track!
Solid race! Congrats to the organizers!

Provided team mechanic support with my usual mobile setup along with an extra awning for the team tent.

Thank you for the opportunity!

18/11/2022

See you guys on Sunday at the Karhakas Gravity Team 2022 Downhill race at 3skulls DH track in Tagaytay!
I'll be supporting the FLY Racing Bike PH team and provide free basic tech support to the race participants wearing their Fly Racing Gear and Apparel.

Race mode on! Show off your FLY Racing Gear & Apparel and get FREE basic race tech support from Bike Fix PH ⚙️ 🏁 Get special discount at the FLY Racing booth too!

17/11/2022

Fluid flush for these TRP HYRD brakes
These brakes and similar designs are prone to becoming spongy. Due to the close proximity of the caliper and reservoir, the heat from the brake pads have less chance to dissipate before oveheating the whole system. My suggestion is to use bigger rotors. Avoid the usual 140mm rear rotor on some road and gravel bikes and go with 160mm front and rear. Also learn to use both brakes and to modulate braking pressure. Avoid continuous use of just one brake as this will cause an overheat and boil the brake fluid.