Parallel Gunworks LLC

Parallel Gunworks LLC Small gunsmith shop located in Lewistown Montana

09/02/2026

Customer wanted it threaded for a future suppressor, but wasn’t sure what optics or sights they wanted. No problem, we can just put the sight back on until then.

Trying something new. I’ve never built an oddball gun and had a company build the exact bullet I desired until now!I bu...
07/20/2026

Trying something new. I’ve never built an oddball gun and had a company build the exact bullet I desired until now!

I built a 6mm Re*****on on a R***r M77. I used an Outlier Backdraft Carbon barrel and suppressor system with a 7 twist. Something unimaginable when the 6mm was first developed.

Then along comes Berger and drops the 120 grain 6mm LRHT on me. The perfect bullet for this set up! I am still working on a load for this, but with a .328 g7 bc this thing is hopefully going to be awesome! I’ll post some load data later and hopefully group photos.

I think bronze adds a neat touch to this custom thread protector.
05/09/2026

I think bronze adds a neat touch to this custom thread protector.

It only took 3 years to make these screws… I got right on that. They were plain steel set screws with a copper disk tha...
05/05/2026

It only took 3 years to make these screws… I got right on that. They were plain steel set screws with a copper disk that holds the spider to the spindle. THREE years of dropping those disks. I cleared off the job sheet and finally got this done. Now back to real gun projects.

I’m not very good at double checking everything on my fi****ms when I’m into an exciting hunt. So I decided to add a se...
04/30/2026

I’m not very good at double checking everything on my fi****ms when I’m into an exciting hunt. So I decided to add a serious zero stop to my Arken SH4j. Pin in hole. Simple enough

These reduced length Mark 4’s are fun to shoot! With the Lane Scorpion Rimfire it only adds a short length and can stil...
02/19/2026

These reduced length Mark 4’s are fun to shoot! With the Lane Scorpion Rimfire it only adds a short length and can still be holstered.

I wasn’t sure how to blend the solder line after removing the ramp. So I just made a long adapter to leave a 5/8 threade...
02/13/2026

I wasn’t sure how to blend the solder line after removing the ramp. So I just made a long adapter to leave a 5/8 threaded muzzle. Re*****on 721

I’m cutting down a few R***r Mark 4’s for suppressors. It’s been a minute since I made this cat head holder and don’t g...
02/08/2026

I’m cutting down a few R***r Mark 4’s for suppressors. It’s been a minute since I made this cat head holder and don’t get to use it much, but I think it works perfect for these barreled uppers.

Sometimes they come out the easy way, sometimes not. Easy-Outs save the day again.
02/07/2026

Sometimes they come out the easy way, sometimes not. Easy-Outs save the day again.

Fresh set of wood jaws for the vise! We will see how they hold up. They look pretty slick when they are brand new. They...
01/10/2026

Fresh set of wood jaws for the vise! We will see how they hold up. They look pretty slick when they are brand new. They are really simple to make. Pressed in neodymium magnets.

Address

Lewistown, MT
59457

Telephone

+14063666645

Website

Alerts

Be the first to know and let us send you an email when Parallel Gunworks LLC posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Parallel Gunworks LLC:

Shortcuts

Share

Category